Fabric not feeding
Also: Fabric won't feed
beginnerStub
Fabric that stalls under the presser foot is typically caused by dropped feed dogs, too-light foot pressure, or lint packed under the plate. Check the feed dog setting, raise foot pressure, and clean out lint.
This article is a stub.
Know this technique? Help write it.
See also
Presser foot pressure wrong
Too much foot pressure flattens pile and stretches knits; too little lets fabric wander or fail to feed. Adjust the pressure dial to suit the fabric weight, lowering it for delicate or bulky fabrics.
Bent needle
A needle that clicks against the plate or skips stitches is often bent from nicking a pin or age. Replace it immediately, since a bent needle can also throw off hook timing.
Machine eating fabric
Fabric pulled down into the needle plate at the start of a seam happens when feed dogs grab thin fabric before the stitch locks. Start on a scrap leader and hold both threads taut behind the foot.
Machine jamming
A machine that locks up, often with a knot of thread underneath, usually means the bobbin is threaded backward or wound around the case. Clear the jam by hand, rewind the bobbin, and rethread from scratch.
Machine skipping on knits
Skipped stitches on knit fabric happen when the needle pushes fabric down into the plate hole instead of piercing it, usually from a sharp needle or overly stretched fabric. Switch to a ballpoint needle and support the fabric.
Edited 9 h · 1 views
Threads about Fabric not feeding