Uneven stitch length
beginnerStub
Stitches that vary in size along a seam usually come from inconsistent feeding, a dull needle snagging the weave, or pulling fabric by hand instead of letting the feed dogs work. Let the machine feed naturally.
This article is a stub.
Know this technique? Help write it.
See also
Loopy stitches
Visible loops sitting proud of the seam point to unbalanced tension, most often a bobbin thread with too little resistance. Rethread top and bobbin, adjust tension gradually, and test on scrap first.
Loose stitches
Stitches that sit slack and don't lock into the fabric come from top tension set too low. Increase the top tension gradually and test until stitches lock in the middle of the fabric.
Puckered seams
A seam that gathers or ripples along its length is caused by tension set too tight, a stitch length wrong for the fabric, or sewing fine fabric without stabilizing. Loosen tension and stabilize lightweight fabrics.
Bobbin thread showing on top
Dots of bobbin-colored thread on the fabric's right side mean top tension is too tight relative to the bobbin, pulling bobbin thread up through the fabric. Loosen the top tension and test on a scrap.
Serger tension problems
Loose loops hanging off a serged edge, or an edge that curls and puckers, points to the tension dials being out of balance for the thread and fabric. Adjust one dial at a time on a scrap.
Edited 8 h · 1 views
Threads about Uneven stitch length